ABB 1SBL241001R8010 switching-path review
Use this switching-path record to decide whether ABB 1SBL241001R8010 matches the intended control circuit and mechanical assembly.
Verified technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SBL241001R8010 |
| Product family | A26-30-10 |
| Component role | three-pole A26 contactor with one NO auxiliary |
| Exact ABB order code | 1SBL241001R8010 |
| Product series | A26-30-10 |
| Main poles | 3 |
| Auxiliary | 1 NO |
| Coil | 220–230 V 50 Hz / 230–240 V 60 Hz for R8010 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
The ABB 1SBL241001R8010 parameters above come from the cited ABB source. Verify any option-dependent value on the delivered unit before energizing it.
1. Confirm the ordering identity
Record the complete ABB 1SBL241001R8010 code from the marking, quotation and approved drawing. An ABB series name alone cannot establish the supplied coil or contact arrangement.
Treat ABB 1SBL241001R8010 as the precise purchasing identity, including suffixes. A product photograph is a reference, not proof of the exact delivered configuration.
4. Test mechanical and accessory fit
Verify ABB 1SBL241001R8010 dimensions, mounting, terminal access, interlocks and accessory-block fit against the panel drawing and manufacturer instructions.
Check the enclosure clearances for ABB 1SBL241001R8010, not only the face dimensions. Specify optional auxiliary blocks separately where the control design needs them.
2. Draw the current and signal paths
Map the conductors that ABB 1SBL241001R8010 will switch and the indication path returning to the controller. The intended job is to switch a mid-size three-phase feeder.
Before installing ABB 1SBL241001R8010, check the real load, utilization category, contact plan and any required protective device in the full circuit.
3. Match the actuator supply
Compare the ABB 1SBL241001R8010 control-coil code to measured supply voltage, frequency or DC source. Distinct coil suffixes within a family are not plug-in equivalents by assumption.
For ABB 1SBL241001R8010, check coil code, load and NO signal; preserve a record of the verified coil marking and control-source rating.
6. Decide on substitutions explicitly
If ABB 1SBL241001R8010 is unavailable, compare the suggested alternative's coil, main poles, auxiliary contacts, duty, approvals, mounting and wiring one field at a time.
Do not mark another code as an automatic replacement for ABB 1SBL241001R8010; secure engineering approval and keep the differences with the equipment record.
5. Commission the entire assembly
After safe isolation and installation by qualified personnel, prove poles and NO indication. Check normal operation, release and relevant failure indication.
An ABB 1SBL241001R8010 acceptance record should include the commanded sequence, contact-state observations and the protective-system result.
Same-series order codes kept on this page
The following codes are associated with ABB 1SBL241001R8010 and will not receive separate product pages. Review each complete code, particularly coil suffixes; listing does not imply direct interchangeability.
- 1SBL241001R8810
Release criterion
Release ABB 1SBL241001R8010 for purchase only after the full code, duty, coil and terminal layout agree with the approved design.
File the ABB 1SBL241001R8010 commissioning result, source reference and as-left drawing together for future maintenance.
