ABB 1SBL921074R2610 contact and coil decision record
Use this switching-path record to decide whether ABB 1SBL921074R2610 matches the intended control circuit and mechanical assembly.
Verified technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SBL921074R2610 |
| Product family | AX18-30-10-26 |
| Component role | three-pole AX18 contactor with one NO auxiliary |
| Exact ABB order code | 1SBL921074R2610 |
| Product series | AX18-30-10-26 |
| Main poles | 3 |
| Auxiliary | 1 NO |
| Coil | 110–127 V AC 60 Hz for -26; check 50 Hz marking |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
The ABB 1SBL921074R2610 parameters above come from the cited ABB source. Verify any option-dependent value on the delivered unit before energizing it.
2. Draw the current and signal paths
Map the conductors that ABB 1SBL921074R2610 will switch and the indication path returning to the controller. The intended job is to switch a compact motor feeder.
Before installing ABB 1SBL921074R2610, check the real load, utilization category, contact plan and any required protective device in the full circuit.
1. Confirm the ordering identity
Record the complete ABB 1SBL921074R2610 code from the marking, quotation and approved drawing. An ABB series name alone cannot establish the supplied coil or contact arrangement.
Treat ABB 1SBL921074R2610 as the precise purchasing identity, including suffixes. A product photograph is a reference, not proof of the exact delivered configuration.
4. Test mechanical and accessory fit
Verify ABB 1SBL921074R2610 dimensions, mounting, terminal access, interlocks and accessory-block fit against the panel drawing and manufacturer instructions.
Check the enclosure clearances for ABB 1SBL921074R2610, not only the face dimensions. Specify optional auxiliary blocks separately where the control design needs them.
3. Match the actuator supply
Compare the ABB 1SBL921074R2610 control-coil code to measured supply voltage, frequency or DC source. Distinct coil suffixes within a family are not plug-in equivalents by assumption.
For ABB 1SBL921074R2610, check coil code, duty and NO indication; preserve a record of the verified coil marking and control-source rating.
5. Commission the entire assembly
After safe isolation and installation by qualified personnel, test poles and feedback. Check normal operation, release and relevant failure indication.
An ABB 1SBL921074R2610 acceptance record should include the commanded sequence, contact-state observations and the protective-system result.
6. Decide on substitutions explicitly
If ABB 1SBL921074R2610 is unavailable, compare the suggested alternative's coil, main poles, auxiliary contacts, duty, approvals, mounting and wiring one field at a time.
Do not mark another code as an automatic replacement for ABB 1SBL921074R2610; secure engineering approval and keep the differences with the equipment record.
Same-series order codes kept on this page
The following codes are associated with ABB 1SBL921074R2610 and will not receive separate product pages. Review each complete code, particularly coil suffixes; listing does not imply direct interchangeability.
- 1SBL921074R8410
Release criterion
Release ABB 1SBL921074R2610 for purchase only after the full code, duty, coil and terminal layout agree with the approved design.
File the ABB 1SBL921074R2610 commissioning result, source reference and as-left drawing together for future maintenance.
