Identifying and maintaining ABB 1SCA022061R3300
This field-service note identifies ABB 1SCA022061R3300 and the checks that separate its exact configuration from visually similar equipment.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SCA022061R3300 |
| Product family | OETLZW9 |
| Component role | simultaneous operating mechanism for paired switches |
| Exact ABB order code | 1SCA022061R3300 |
| Product series | OETLZW9 |
| Function | Coupled switch operation |
| Host | Selected OT315–OT800 units |
| Arrangement | Check six- or eight-pole paired assembly |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
For ABB 1SCA022061R3300, confirm version-specific limits against its marking and the cited ABB publication before applying the table to an installation.
Nameplate and order-code checkpoint
Start the service record with ABB 1SCA022061R3300, including every character of its ordering code. Confirm the delivered marking and the installed equipment drawing agree before changing wiring or ordering a spare.
The family image for ABB 1SCA022061R3300 is a reference image; it cannot establish the exact contact layout, coil, actuator or approved accessory combination.
Normal-duty path
In the intended assembly, ABB 1SCA022061R3300 is used to coordinate two switch handles. Trace the energy or signal path from supply through the device and onward to the controlled equipment.
For ABB 1SCA022061R3300, verify host size, pole arrangement and linkage geometry. Treat a similar catalog number as a different configuration until the full ABB designation has been compared.
Failure symptoms and first checks
If ABB 1SCA022061R3300 fails to switch or signal correctly, isolate the system under the approved procedure and compare the observed state with the electrical drawing. Check supply, wiring, host fit and mechanical travel before replacing parts.
Record any ABB 1SCA022061R3300 abnormal heating, loose termination, damaged enclosure or inconsistent contact timing. Do not infer a root cause from the part photograph alone.
Installation and restoration
Qualified personnel should fit ABB 1SCA022061R3300 only within the applicable electrical ratings, isolation rules and manufacturer instructions. Verify terminal treatment, mounting clearance and the companion component specified for the installation.
After work on ABB 1SCA022061R3300, prove matched switching travel. Capture the tested state and the as-left code in the maintenance record.
Spare and substitution decision
A substitute for ABB 1SCA022061R3300 needs a documented match in electrical duty, geometry, terminal style and any safety or environmental approvals. Similar-looking variants are not automatically interchangeable.
Keep ABB 1SCA022061R3300 as the purchase reference until engineering confirms a different code. The full source link below can be used to review the manufacturer's family information.
Handover record
For ABB 1SCA022061R3300, retain the exact code, service date, measured or observed contact state and any companion equipment identification. This helps the next technician repeat the acceptance check.
Before closing a work order for ABB 1SCA022061R3300, compare the installed condition with the approved operating and fault-response sequence.
Manufacturer reference and sign-off
ABB 1SCA022061R3300 should be accepted only after the device identity, application duty and installation test are documented.
Use the ABB 1SCA022061R3300 manufacturer reference to resolve any option or revision that this general service note does not decode.
