Technical selection record for ABB 2CCA880000R0001

ABB 2CCA880000R0001 is the representative order reference for CMS-600 current monitoring system. This page separates verified catalog data from site-specific checks so buyers can specify the correct item for measure branch current with matching sensors.

Technical specification and configuration limits

The table describes ABB 2CCA880000R0001, not every item in its wider series. Confirm the actual label and the current ABB product documentation for the unit being supplied.

Use case and system boundary

The intended duty for ABB 2CCA880000R0001 is to measure branch current with matching sensors. Define the affected circuit, machine or network and record its normal and fault states. The product should be selected for that actual duty, not merely because the order code resembles an older spare.

For ABB 2CCA880000R0001, distinguish the functional device from its accessories and from other ratings in CMS-600 current monitoring system. A related catalog reference is a family-navigation aid, not an automatic substitute.

Purchasing specification

Request ABB 2CCA880000R0001 by complete designation. Add the required supply, current, interface, enclosure, revision and regulatory approvals to the purchase document. Any proposed alternative should be accompanied by a written difference check.

For ABB 2CCA880000R0001, check sensor rating, cable path, address and 24 V supply. Confirm availability and lifecycle status with the supplier, especially when an older assembly or control platform is involved.

Interface review

Before fitting ABB 2CCA880000R0001, compare the equipment drawing, terminal numbering, mounting space and connected load with the actual installed plant. Review the application-specific electrical or communications interface and any relevant software configuration.

Do not infer compatibility from a photograph of ABB 2CCA880000R0001. Mechanical fit, wiring, firmware, thermal conditions and protection coordination may all vary within a nominal series.

Receiving inspection

On arrival, identify ABB 2CCA880000R0001 from its nameplate, box and order paperwork. Inspect for damage, missing hardware and revision differences. Keep questionable material separate until the engineering team resolves the discrepancy.

Record the full ABB 2CCA880000R0001 designation against the asset or spare-part register. Preserve the manufacturer's instructions and any configuration record needed for later replacement.

Installation and acceptance

Only qualified personnel should install ABB 2CCA880000R0001 under the approved isolation and safe-work procedure. After correct assembly, confirm sensor channels and Modbus values. Test the function that the circuit or process actually relies on.

The commissioning record for ABB 2CCA880000R0001 should include settings, test conditions, observed responses, drawing revision and approval. If the result differs from expectation, resolve the cause before putting the asset back into service.

Future maintenance

Store ABB 2CCA880000R0001 with a traceable part number and the configuration evidence. During future maintenance, compare the installed unit to the approved reference before any order is placed.

If ABB 2CCA880000R0001 is replaced with another member of CMS-600 current monitoring system, repeat the rating, interface and safety review. Similar family names do not prove equivalence.

Related order references in this ABB series

The following references belong to the concrete CMS-600 current monitoring system range or a directly paired system for ABB 2CCA880000R0001. Ratings, function and host fit may differ. Each listed reference is covered here and will not receive a separate product page.

• 2CCA880101R0001
• 2CCA880102R0001

Release decision

Approve ABB 2CCA880000R0001 only after the catalog identity, site interfaces and acceptance checks agree.

Keep the approved ABB 2CCA880000R0001 record available for the next repair or purchasing cycle.