Commissioning brief: ABB AF09Z-30-10-21
Use the complete ABB AF09Z-30-10-21 designation for the purchase and asset record. The short family mark alone cannot establish electrical ratings, process options or interchangeability.
Technical selection record
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | AF09Z-30-10-21 |
| Product family | AF09Z |
| Component role | low-consumption three-pole contactor |
| Main contacts | 3 normally-open |
| Built-in auxiliary | 1 normally-open |
| Control coil | 24-60 V AC or 20-60 V DC |
| ABB order code | 1SBL136001R2110 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Values shown for AF09Z-30-10-21 are selection checkpoints. Confirm the fitted unit, nameplate and ABB documentation before releasing an order or a site change.
Installation sequence
Before fitting AF09Z-30-10-21, isolate the affected system by the plant procedure and preserve the approved settings or wiring schedule. Verify mechanical seating and each identified connection.
After connecting AF09Z-30-10-21, check power, communications and local indications before enabling the controlled equipment.
Application decision
The intended duty of AF09Z-30-10-21 is to switch the specified small motor or load under PLC or panel command. Record the controlled asset, panel location and circuit or process tag next to the exact code.
A specification for AF09Z-30-10-21 should state the operating conditions rather than assuming another AF09Z item is a drop-in replacement.
Fit and interface gate
Compare AF09Z-30-10-21 with the existing installation for coil range, AC-3 load current, overload relay, auxiliary logic and screw terminals. Keep photos of the nameplate, terminals and accessory arrangement with the enquiry.
If any connector, protective rating or configuration item differs, hold the AF09Z-30-10-21 substitution for engineering review.
Acceptance evidence
At handover for AF09Z-30-10-21, measure pickup and release and confirm the load and auxiliary feedback. Record who witnessed the test, the measured results and any open action.
The AF09Z-30-10-21 asset record should retain the final configuration, revision and commissioning evidence for later troubleshooting.
Related configuration codes
Other AF09Z designations recorded with AF09Z-30-10-21 are shown below for search and enquiry. Their options and ratings can differ; the list does not claim automatic interchangeability.
No further unassigned AF09Z designation is grouped with AF09Z-30-10-21 on this page.
Purchase handoff
Quote the complete AF09Z-30-10-21 designation, the installation tag and the critical interface checks. Ask for nameplate and revision confirmation before dispatch.
When AF09Z-30-10-21 arrives, compare the received unit to the approved selection record and document the final acceptance result.
