How to confirm CP1-30G-10 in service
Keep the entire CP1-30G-10 designation with the maintenance request. CP1-30G-10 belongs to a specific equipment design; the visible family name alone is insufficient for a replacement decision.
Product data and selection limits
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | CP1-30G-10 |
| Product family | CP1 |
| Component role | green momentary pushbutton |
| Action | Momentary |
| Actuator | Flush green |
| Contact | 1 NO |
| Illumination | None |
| Order code | 1SFA619100R3012 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
For CP1-30G-10, the table identifies useful checks but does not replace the marked unit and its complete technical documentation. Confirm option and revision details before purchase.
What the replacement must match
Before substituting CP1-30G-10, compare panel hole, contact function, color convention, actuator travel and connected input voltage. Check the exact code and nameplate against the purchase specification.
Do not call another CP1 designation a direct replacement for CP1-30G-10 solely because its enclosure looks similar. Ratings and fitted options require separate confirmation.
Equipment role
The installed role of CP1-30G-10 is to issue a momentary command at the local operator panel. Write down the connected circuit, controller or process tag and the equipment being served.
A failure around CP1-30G-10 may also arise from the supply, sensor, wiring, communications or mechanical accessory. Capture the symptoms before removing parts.
Commissioning handover
After fitting CP1-30G-10, prove release and actuation states at the receiving circuit. Record the test method, readings, settings and any open deviation.
Release CP1-30G-10 for service only after the relevant protection, communication or measurement response has been witnessed and the asset record is updated.
Field fault isolation
For an unexplained CP1-30G-10 fault, note the present indicators and alarm history. Measure only at safe accessible test points according to the plant procedure.
When CP1-30G-10 interacts with a controller or protective system, verify the upstream command and downstream response independently before deciding which component failed.
Related family designations
These CP1 designations are included with CP1-30G-10 to support model searches and enquiries. Individual specifications can differ, and they are not automatically interchangeable.
- CP1-30R-10
Ordering record
Retain the CP1-30G-10 nameplate image, purchase code and configuration note with the quotation. Include the commissioning results when the unit is installed.
If a future CP1-30G-10 replacement is required, compare its complete code with the installed record again rather than relying on this page alone.
