Technical selection record for ABB LD 800HSE, 3BSE073314R1

ABB LD 800HSE, 3BSE073314R1 is the representative order reference for LD 800HSE EX linking devices. This page separates verified catalog data from site-specific checks so buyers can specify the correct item for bridge HSE and H1 fieldbus segments.

Technical specification and configuration limits

The table describes ABB LD 800HSE, 3BSE073314R1, not every item in its wider series. Confirm the actual label and the current ABB product documentation for the unit being supplied.

Interface review

Before fitting ABB LD 800HSE, 3BSE073314R1, compare the equipment drawing, terminal numbering, mounting space and connected load with the actual installed plant. Review the application-specific electrical or communications interface and any relevant software configuration.

Do not infer compatibility from a photograph of ABB LD 800HSE, 3BSE073314R1. Mechanical fit, wiring, firmware, thermal conditions and protection coordination may all vary within a nominal series.

Use case and system boundary

The intended duty for ABB LD 800HSE, 3BSE073314R1 is to bridge HSE and H1 fieldbus segments. Define the affected circuit, machine or network and record its normal and fault states. The product should be selected for that actual duty, not merely because the order code resembles an older spare.

For ABB LD 800HSE, 3BSE073314R1, distinguish the functional device from its accessories and from other ratings in LD 800HSE EX linking devices. A related catalog reference is a family-navigation aid, not an automatic substitute.

Purchasing specification

Request ABB LD 800HSE, 3BSE073314R1 by complete designation. Add the required supply, current, interface, enclosure, revision and regulatory approvals to the purchase document. Any proposed alternative should be accompanied by a written difference check.

For ABB LD 800HSE, 3BSE073314R1, check EX approval, redundant partner, firmware and H1 power. Confirm availability and lifecycle status with the supplier, especially when an older assembly or control platform is involved.

Installation and acceptance

Only qualified personnel should install ABB LD 800HSE, 3BSE073314R1 under the approved isolation and safe-work procedure. After correct assembly, check network and H1 link diagnostics. Test the function that the circuit or process actually relies on.

The commissioning record for ABB LD 800HSE, 3BSE073314R1 should include settings, test conditions, observed responses, drawing revision and approval. If the result differs from expectation, resolve the cause before putting the asset back into service.

Receiving inspection

On arrival, identify ABB LD 800HSE, 3BSE073314R1 from its nameplate, box and order paperwork. Inspect for damage, missing hardware and revision differences. Keep questionable material separate until the engineering team resolves the discrepancy.

Record the full ABB LD 800HSE, 3BSE073314R1 designation against the asset or spare-part register. Preserve the manufacturer's instructions and any configuration record needed for later replacement.

Future maintenance

Store ABB LD 800HSE, 3BSE073314R1 with a traceable part number and the configuration evidence. During future maintenance, compare the installed unit to the approved reference before any order is placed.

If ABB LD 800HSE, 3BSE073314R1 is replaced with another member of LD 800HSE EX linking devices, repeat the rating, interface and safety review. Similar family names do not prove equivalence.

Release decision

Approve ABB LD 800HSE, 3BSE073314R1 only after the catalog identity, site interfaces and acceptance checks agree.

Keep the approved ABB LD 800HSE, 3BSE073314R1 record available for the next repair or purchasing cycle.