Commissioning brief: ABB PM566-TP-ETH
Use the complete ABB PM566-TP-ETH designation for the purchase and asset record. The short family mark alone cannot establish electrical ratings, process options or interchangeability.
Technical selection record
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | PM566-TP-ETH |
| Product family | PM566-TP-ETH |
| Component role | AC500-eCo PLC processor with mixed I/O |
| Program memory | 512 kB |
| Integrated I/O | 6 DI, 6 transistor DO, 2 AI, 1 AO |
| Supply | 24 V DC |
| Network | Onboard Ethernet |
| ABB order code | 1SAP121500R0071 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Values shown for PM566-TP-ETH are selection checkpoints. Confirm the fitted unit, nameplate and ABB documentation before releasing an order or a site change.
Fit and interface gate
Compare PM566-TP-ETH with the existing installation for project and firmware, terminal blocks, Ethernet settings, I/O mapping and 24 V power budget. Keep photos of the nameplate, terminals and accessory arrangement with the enquiry.
If any connector, protective rating or configuration item differs, hold the PM566-TP-ETH substitution for engineering review.
Installation sequence
Before fitting PM566-TP-ETH, isolate the affected system by the plant procedure and preserve the approved settings or wiring schedule. Verify mechanical seating and each identified connection.
After connecting PM566-TP-ETH, check power, communications and local indications before enabling the controlled equipment.
Application decision
The intended duty of PM566-TP-ETH is to execute the machine program and its local digital and analog signals. Record the controlled asset, panel location and circuit or process tag next to the exact code.
A specification for PM566-TP-ETH should state the operating conditions rather than assuming another PM566-TP-ETH item is a drop-in replacement.
Acceptance evidence
At handover for PM566-TP-ETH, restore the validated project and test every used I/O and network connection. Record who witnessed the test, the measured results and any open action.
The PM566-TP-ETH asset record should retain the final configuration, revision and commissioning evidence for later troubleshooting.
Related configuration codes
Other PM566-TP-ETH designations recorded with PM566-TP-ETH are shown below for search and enquiry. Their options and ratings can differ; the list does not claim automatic interchangeability.
No further unassigned PM566-TP-ETH designation is grouped with PM566-TP-ETH on this page.
Purchase handoff
Quote the complete PM566-TP-ETH designation, the installation tag and the critical interface checks. Ask for nameplate and revision confirmation before dispatch.
When PM566-TP-ETH arrives, compare the received unit to the approved selection record and document the final acceptance result.
