X20CP0484: X20 Compact-S controller in the installed X20 station
X20CP0484 is a B&R X20 component in the ABB automation portfolio. The page below is a fault-isolation and replacement guide for this exact designation.
Technical identification
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | X20CP0484 |
| CPU | ARM Cortex-A9, 667 MHz |
| RAM | 256 MB DDR3 |
| Flash | 2 GB onboard |
| Interfaces | Ethernet, POWERLINK, RS232 and two USB |
Published values help identify X20CP0484. Confirm the specific installed revision, approvals and environmental limits before engineering sign-off.
Installed duty
For X20CP0484, Controller replacement requires a complete project and device inventory, not only a CPU-speed match.
Document the real load or signal connected to X20CP0484, its normal range and the response required when that signal is lost. This makes the product decision specific to the station rather than the family name.
Fault isolation and proving
When recommissioning X20CP0484, A version mismatch can block startup. Back up the project, prove boot, I/O, network and machine interlocks, and keep a rollback plan.
Record the as-left status of X20CP0484: channel values, alarms, supply state and any changed settings. Work under the plant's electrical and machine safety rules.
Fit check
Before buying X20CP0484, Verify base, power module, interface slot, firmware and Automation Studio project. The X20CP0484-1 is a newer distinct revision with different RAM.
Keep the complete X20CP0484 designation on the RFQ together with hardware revision, X20 base, terminal block, controller project and a photograph of the installed unit.
Related order-code references
These designations are associated with X20CP0484 by their product-line code; differences in channel count, electrical mode, firmware or safety approval must be checked. They are not automatic replacements.
No additional same-code reference is shown for X20CP0484. Other X20 parts require separate selection.
Closeout
The purchase order and maintenance report should both identify X20CP0484 without abbreviating the code. Ask the supplier to confirm accessories and any approved successor in writing.
Release X20CP0484 only after the intended field signal or power path has been demonstrated and the controller team accepts the test result.
