X20IF10D3-1: practical fit and verification for ethernet/ip adapter interface
X20IF10D3-1 is a B&R X20 component in ABB's automation portfolio. This page concentrates on the exact X20IF10D3-1 order designation, its documented functional role and the practical checks needed before installation.
Technical identification
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | X20IF10D3-1 |
| Interface | EtherNet/IP adapter (slave) |
| Configuration | DTM |
| Isolation | Electrically isolated |
The table identifies X20IF10D3-1 using manufacturer-published family data. Verify the actual hardware revision, approvals and environmental limits on the installed unit before final engineering approval.
Application decision
X20IF10D3-1: Connect the X20 controller to a scanner using the approved EtherNet/IP assembly mapping.
Before assigning X20IF10D3-1 to a station, capture the attached devices, signal or network role, expected failure response and revision-dependent requirements. A family resemblance alone does not prove interchangeability.
Commissioning evidence
When checking X20IF10D3-1, Confirm connection establishment, I/O ownership, timeout response and fault recovery.
Record an as-left result for X20IF10D3-1, including channel or network status, the observed alarm behavior and a backup of any changed settings. Work under the plant's electrical and machine-safety procedures.
Compatibility boundary
For X20IF10D3-1, Retain firmware and DTM settings, IP addressing and connection parameters. Adapter and scanner roles are not interchangeable.
Procurement should quote the complete X20IF10D3-1 designation and request written confirmation of the compatible X20 base, power module, terminal block, firmware and controller project. Keep the existing panel drawing with the request.
Related designation check
Other X20IF10D3-1 code references, where shown, are comparison leads only. Differences in protocol, channel function, power path or revision can make a similar-looking code unsuitable.
No additional exact-code variant is listed here for X20IF10D3-1; request a manufacturer-approved equivalent when replacement is needed.
Order and handover
Place X20IF10D3-1 on the RFQ and asset record exactly as marked. Include a nameplate photo, quantity, delivery destination and the installed system's wiring and software revision.
Release X20IF10D3-1 only after the field test and controller-side evidence agree. Preserve the accepted configuration and any supplier confirmation for future maintenance.
