X20IF10E3-1 selection record: profinet io device interface and installed-system fit
X20IF10E3-1 belongs to the B&R X20 automation system. Specify X20IF10E3-1 by its complete designation and documented role; the visible similarity of two modules is not a compatibility decision.
Identification matrix
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | X20IF10E3-1 |
| Role | PROFINET IO device (slave) |
| Configuration | DTM |
| Isolation | Electrically isolated |
The values above identify X20IF10E3-1 at catalog level. Verify the installed revision, label and current manufacturer manual before issuing a purchase order or approving a design change.
02 / Fit boundary
When replacing or adding X20IF10E3-1, Confirm device name, slot mapping and firmware; a controller/master interface cannot be substituted for this role.
Check X20IF10E3-1 against the as-built wiring, X20 base, terminal block, supply module and controller software. Keep every accessory and revision difference visible in the RFQ; do not approve a look-alike solely from a photograph.
01 / Intended duty
For X20IF10E3-1, Connect the X20 controller as a configured PROFINET IO device within a higher-level controller project.
Capture the actual cabinet location, connected equipment, expected operating range and the consequence of a lost signal or network connection. These details turn the X20IF10E3-1 code into a specific engineering requirement.
03 / Acceptance record
For commissioning X20IF10E3-1, Prove controller discovery, cyclic data and the required fail-state on network loss.
Record date, test conditions, observed LEDs or diagnostics and as-left configuration for X20IF10E3-1. Restore normal control after testing and obtain the site's electrical or safety sign-off where required.
Code alternatives and exclusions
The references below, if any, share a relevant X20IF10E3-1 code stem or functional family. Their ratings, ports, wiring or software may differ; they are not automatic replacements.
No additional exact-stem variant is assigned to X20IF10E3-1 here; seek written manufacturer confirmation for any alternative.
Purchase handover
Quote X20IF10E3-1 exactly, with quantity, required delivery, existing hardware revision and a readable label photograph. Attach the application drawing and network or channel map so the supplier can confirm the right product and accessories.
The buyer should retain a written fit decision for X20IF10E3-1, and maintenance should keep the final settings and test evidence. Do not energize a replacement until the approved checks are complete.
