How to confirm SLPCM10-3-R-L/31 before it enters a live installation
Pepperl+Fuchs SLPCM10-3-R-L/31 is a safety light grid receiver used for monitoring an access opening with a paired safety emitter. This product page centers on the precise SLPCM10-3-R-L/31 designation and practical fit decisions. Its shared montage is an illustrative category image, not a photograph of the exact variant. Confirm every site-specific electrical, mechanical and approval requirement against the current manufacturer's documentation before a purchase or changeover.
Technical data for the exact designation
| Technical item | Verified value / selection note |
|---|---|
| Exact model | SLPCM10-3-R-L/31 |
| Product role | safety light grid receiver |
| Role | Receiver of a matched safety light grid |
| Matching emitter | SLP10-3-T in the referenced system data |
| System effective range | 0.2 to 10 m with matched pair |
| Connection | Confirm /31 cable and safety-controller interface |
| Variant check | Confirm the complete designation and current manufacturer documentation before replacement. |
Buyer questions
What must SLPCM10-3-R-L/31 connect to?
For SLPCM10-3-R-L/31, check the actual safety function, emitter match, beam geometry and reset logic. Record the installed nameplate, matching device, space envelope and existing configuration. An appearance match is only a starting point: signal direction, power, interface and certification must be considered separately.
How can SLPCM10-3-R-L/31 be accepted on site?
With SLPCM10-3-R-L/31 installed, perform the required interruption and fault tests under the site's safety procedure. Compare observed values with a known test condition and record the controller or diagnostic response. Repeat at the relevant operating limits so that an intermittent wiring or setup problem does not go unnoticed.
What belongs in the SLPCM10-3-R-L/31 order?
For a SLPCM10-3-R-L/31 enquiry, state both receiver and emitter identities; the receiver alone is not a complete protective device. Provide the full label, circuit or mounting drawing and operating conditions. Ask for written confirmation before accepting any substituted suffix, especially when a related-looking code has different terminals, approval or function.
Related-looking designations
These names visually resemble SLPCM10-3-R-L/31 and are grouped as identification references. They may differ in function, circuit values, mounting, communications and hazardous-area approval. Do not apply the technical values of SLPCM10-3-R-L/31 to another complete designation without its own specification.
- SLPCM8-2-A-L/31
Final record
Keep the completed check with the maintenance history for SLPCM10-3-R-L/31. If site conditions change, review the current datasheet and repeat the relevant electrical, mechanical and functional checks. The values in this page identify SLPCM10-3-R-L/31 where stated; they do not define every visually related code.
Further Pepperl+Fuchs look-alike model references
These are additional printed model strings grouped for product search only. A similar-looking code can describe another device, connection, rating or certification. It is not automatically a substitute for SLPCM10-3-R-L/31. Check the full manufacturer designation and the installed system independently.
- SLP8-2-M
