Selection file for ABB CI522A AF100
Use the complete ABB CI522A AF100 designation for the purchase and asset record. The short family mark alone cannot establish electrical ratings, process options or interchangeability.
Technical selection record
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | CI522A AF100 |
| Product family | CI522A |
| Component role | Advant Fieldbus 100 controller interface |
| Platform | Advant Controller 400 |
| Fieldbus | Advant Fieldbus 100 |
| Media | Redundant AF 100 media supported |
| Order code | Confirm 3BSE018283R1 against installed revision |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Values shown for CI522A AF100 are selection checkpoints. Confirm the fitted unit, nameplate and ABB documentation before releasing an order or a site change.
Application decision
The intended duty of CI522A AF100 is to connect the Advant Controller 400 installation to its AF 100 fieldbus. Record the controlled asset, panel location and circuit or process tag next to the exact code.
A specification for CI522A AF100 should state the operating conditions rather than assuming another CI522A item is a drop-in replacement.
Fit and interface gate
Compare CI522A AF100 with the existing installation for controller version, modem cables, redundant bus topology, connector condition and configured station address. Keep photos of the nameplate, terminals and accessory arrangement with the enquiry.
If any connector, protective rating or configuration item differs, hold the CI522A AF100 substitution for engineering review.
Installation sequence
Before fitting CI522A AF100, isolate the affected system by the plant procedure and preserve the approved settings or wiring schedule. Verify mechanical seating and each identified connection.
After connecting CI522A AF100, check power, communications and local indications before enabling the controlled equipment.
Acceptance evidence
At handover for CI522A AF100, compare bus diagnostic status and verify communications on the approved active and standby paths. Record who witnessed the test, the measured results and any open action.
The CI522A AF100 asset record should retain the final configuration, revision and commissioning evidence for later troubleshooting.
Related configuration codes
Other CI522A designations recorded with CI522A AF100 are shown below for search and enquiry. Their options and ratings can differ; the list does not claim automatic interchangeability.
No further unassigned CI522A designation is grouped with CI522A AF100 on this page.
Purchase handoff
Quote the complete CI522A AF100 designation, the installation tag and the critical interface checks. Ask for nameplate and revision confirmation before dispatch.
When CI522A AF100 arrives, compare the received unit to the approved selection record and document the final acceptance result.
